The Float Tube Fishing Forum We're Always On The Fish

Log in

I forgot my password

Latest topics

» Holiday Gift Ideas
by Jerdon Yesterday at 10:25 pm

» Our 7th Annual FTFF Toy Drive is now in effect
by Jerdon Yesterday at 10:23 pm

» What do you think Saltwater VS Freshwater should we?
by jeffcpr Thu Dec 14, 2017 8:42 pm

» Sign up for the 2018 Tournament Series
by jeffcpr Thu Dec 14, 2017 2:39 pm

» Early present
by Hunt Thu Dec 14, 2017 8:41 am

» Santa Ana River Lakes
by GT Mon Dec 11, 2017 10:55 am

» Edge Open Heel Flex Scuba Fin
by jeffcpr Mon Dec 11, 2017 10:34 am

» Wader and Boot Dryer
by SP Dan Sun Dec 10, 2017 5:45 pm

» Frogg Toggs Hellbender Stockingfoot Breathable Guide Pant
by jeffcpr Thu Dec 07, 2017 7:15 pm

» Hello from Vhanaya
by Hunt Thu Dec 07, 2017 7:12 am

» Waterproof Reels - Penn Spinfisher and KastKing Sharky II
by singletrack Sun Dec 03, 2017 6:02 pm

» Fish finder recommendations
by Jerdon Fri Dec 01, 2017 8:29 am

Members benifits
Clearance Banner

Clearance Banner

Clearance Banner

Clearance Banner

Clearance Banner

Clearance Banner

Clearance Banner

You are not connected. Please login or register

FLOAT TUBE FISHING FORUM » Float Tubes, Pontoons and Related Equipment Discussions » Float Tube and Pontoon Tips, Tricks and Mods » does anyone have email pictures of the drill tm mount

does anyone have email pictures of the drill tm mount

View previous topic View next topic Go down  Message [Page 1 of 1]


Hi guys, new here. I was reading some guys made racks for a drill trolling motor setup. I was wondering if anyone had any pictures. I'm learning alot from you guys andi think I want to try it. I've got a Milwaukee 18v impact with 3 speeds and an extra battery laying in my basement


There's not really a mount for it - you just hold the prop shaft down in the water at about a 45* angle and let her rip.
See here:
[You must be registered and logged in to see this link.]


Thanks. I'm gonna attempt to make something then. I was wondering if anyone came up with a swivel arm or something to push it out of the way when not in use and then swivel it so it sits between my legs when needed. Kinda like the ff mount on the front of a rod rack.


I'm just going to put the unit across the tube behind the seat. Might even put a velcro strap around it. I will put the drill motor in a zip lock bag and put it in the netting on the backside of the Cumberland seat.

Sponsored content

View previous topic View next topic Back to top  Message [Page 1 of 1]

Permissions in this forum:
You cannot reply to topics in this forum